Changing the width and height of a particle type

All information about Magic Particles: news, question, comments, etc.

Changing the width and height of a particle type

Postby bfhobbes » Sat Oct 18, 2014 12:27 am

I would like to be be able to specify a fixed height, but a range for the width in the "Size of particle" diagram. I would then like to be just able to adjust the width over the lifetime of the particle using the "Size over life" diagram.

For example, I want the size of particle to be 200 units high, and 50-100 units wide. Over it's lifetime, I want it to stay at 200 units high, and the width to increase overtime by 300%.

Have I missed something obvious or is there no direct way to do this?

thanks for your help
Andy McDonald
bfhobbes
 
Posts: 8
Joined: Fri Oct 17, 2014 11:55 pm

Re: Changing the width and height of a particle type

Postby Odin_KG » Sat Oct 18, 2014 8:01 am

For example, I want the size of particle to be 200 units high, and 50-100 units wide. Over it's lifetime, I want it to stay at 200 units high, and the width to increase overtime by 300%.

Yes, you may change width and height of the particle independently. Use the diagram "Size over life (factor),%". Click on blue square and green line will be added to the diagram.

Best regards,
Alexey Sedov
Attachments
size.jpg
size.jpg (45.96 KiB) Viewed 59772 times
User avatar
Odin_KG
Administrator
Administrator
 
Posts: 255
Joined: Sat May 09, 2009 10:53 pm


Return to Magic Particles

Who is online

Users browsing this forum: No registered users and 2 guests

cron